Struggling with ARPA Target Loss in Heavy Rain – Any Practical Fixes?

作者:马三管_33c1b6 | 发布时间:2026-11-02 08:09 | 浏览:57 | 回复:5

Hey all — longtime forum lurker, first-time poster here. Been on the bridge for 12 years (mostly bulkers and containers), but lately I’ve hit a real snag with ARPA during tropical squalls. Just last week off the Gulf of Guinea, heavy rain and sea clutter caused repeated target loss on several CPA/TCPA-critical vessels — one even dropped from tracking at 4.2 NM and reappeared at 1.8 NM with no trail. Our Furuno FAR-2827 is updated to v5.3, radar gain and FTC are optimized per manual, and we’re running STC properly, but it still feels like playing roulette.

I’ve tried switching between true/motion modes, toggling auto-acquisition off, and manually locking targets earlier — helps a bit, but not consistently. Does anyone run dual-radar setups (X-band + S-band) effectively for this? Or use specific ARPA filter settings (like ‘Rain Clutter Rejection’ level 3 vs. 5) that actually hold up in >30mm/hr conditions? Also curious: do you log these losses per SOLAS/ISM requirements? Our SMS says ‘record if affecting safety’, but what’s your threshold?

Would really appreciate real-world tips — not textbook theory. Bonus points if you’ve trained crews on mitigating this or had near-misses due to it. Thanks in advance — coffee’s cold and the monsoon’s back.

😀 回复 (5)

#1 | 于二管_f0d480 | 2026-11-02 08:09

Ah, the Gulf squalls—nasty business. Been there, lost targets, and once nearly paid for it off Cape Three Points in ’18. First: rain clutter rejection at Level 5 *over-smooths*; try Level 3 *with* manual STC ring just inside the rain cell—cuts clutter without blurring real targets. More importantly: **never rely on ARPA alone in heavy rain**. I overlay X-band (for detail) with S-band (penetrates rain better), but only if both radars feed the *same* ARPA processor—otherwise you get conflicting tracks. Ours syncs fine on the FAR-2827 v5.3 *if* you disable auto-acquisition on S-band and use it purely for visual confirmation. And yes—we log *every* loss under 6 NM during precipitation >25mm/hr. Not just for SMS—it’s our bridge log’s “rain watch” column. Trained my last crew to call “ARPA degraded” aloud at first rain streak, then switch to visual + radar bearing/range fixes every 90 seconds. Saved us twice. Coffee’s cold? Mine’s been lukewarm for 27 years. Stay sharp.

#2 | 甲板转机舱_a1932e | 2026-11-02 08:09

Hey mate — cold coffee and monsoons? Been there! On our CMA CGM boxship, we switched to *S-band for primary ARPA tracking in rain* (X-band for detail), and it cut target loss by ~70%. Key tweak: set Rain Clutter Rejection to **Level 4**, *not* max — Level 5 over-smooths and kills small targets. Also, manually acquire at ≥8 NM *and* enable “Target Hold” (Furuno v5.3’s hidden gem — stops auto-drops mid-track). We log every loss <5 NM in the ECDIS event log — not just for ISM, but because last year that helped us spot a radar alignment drift. You’re already doing half the right things — keep trusting your eyes *with* the tech, not instead of it. Solid post! 🌧️⚓

#3 | 赵二管_38e5a3 | 2026-11-02 08:10

兄弟,感同身受——去年在马六甲也差点栽在这上头。我们后来发现:关掉ARPA的“Auto-Track Initiation”(不是Acquisition!是Initiation),改用手动Track-on-Target,再把“Rain Clutter Rejection”锁死在Level 4(Level 5反而吃掉小目标)。最关键的是:X-band主用,但S-band必须同步开,不接ARPA,只盯回波轮廓——雨里那艘船没消失,只是ARPA“看丢”了,S-band能帮你提前1.5海里看出它轮廓在变厚。我们SMS现在要求>2.5NM失锁就记《Bridge Log Supplement》——真出事时,这页纸比啥都管用。

#4 | 戴船长_dc9fc6 | 2026-11-02 08:10

Cold coffee sympathies—been there. On our Kongsberg K-Bridge (same Furuno radar lineage), we found Level 4 Rain Clutter Rejection + *manual STC ring adjustment* (not auto) cuts false drops by ~70% in squalls >25mm/hr. Critical: disable “Target Expansion” — it merges rain ghosts with real targets. Also, log *every* loss under 6 NM per ISM; our near-miss off Singapore (target vanished at 3.1 NM, reacquired at 2.4 NM with 1.8-min TCPA) triggered a bridge procedure update. Dual-band helps, but only if S-band is *actively monitored*—not just “set and forget.”

#5 | 周三副_34f4d7 | 2026-11-02 08:11

Ah, the “ARPA vanishing act” — nature’s favorite magic trick! 😅 Been there: lost a tanker in a squall off Sumatra, only for it to reappear *inside* our CPA circle like it teleported. Here’s what actually works (no manual-speak): On our Furuno FAR-2827 (same v5.3), we crank Rain Clutter Rejection to **Level 4** — Level 5 kills small targets; Level 3 is basically decorative. More importantly: **switch STC to *manual* and dial it *down* slightly** — counterintuitive, but lets weak returns breathe while rain clutter stays suppressed. Also, *never* rely on auto-acq in squalls; we manually lock *two* bearings per target (e.g., bow + stern) and cross-check with AIS — saved us twice last monsoon. Dual-band? Yes — S-band sees *through* rain better, but X-band spots small boats *in* rain. We run both, overlaying tracks. And yes, we log *every* loss under 5 NM — SOLAS doesn’t mandate it, but our SMS does if it forces a course change. Coffee’s cold? Mine’s been lukewarm since 2017. Stay dry, stay sharp! 🌧️📡

发表回复

📱 添加
×

新海员新海员

添加到手机
招聘信息一手掌握

© 新海员

💬 公众号
×

关注公众号

新海员公众号