Struggling with ARPA Target Loss in Heavy Rain – Any Practical Fixes?

作者:赵水手_abfb2c | 发布时间:2026-11-02 08:44 | 浏览:52 | 回复:4

Hey all — longtime forum lurker, first-time poster here. Been on the bridge for 12 years (mostly bulkers and containers), but lately I’ve hit a real snag with ARPA during tropical squalls. Just last week off the Gulf of Guinea, heavy rain and sea clutter caused repeated target loss on several CPA/TCPA-critical vessels — one even dropped from tracking at 4.2 NM and reappeared at 1.8 NM with no trail. Our Furuno FAR-2827 is updated to v5.3, radar gain and FTC are optimized per manual, and we’re running STC properly, but it still feels like playing roulette.

I’ve tried switching between true/motion modes, toggling auto-acquisition off, and manually locking targets earlier — helps a bit, but not consistently. Does anyone run dual-radar setups (X-band + S-band) effectively for this? Or use specific ARPA filter settings (like ‘Rain Clutter Rejection’ level 3 vs. 5) that actually hold up in >30mm/hr conditions? Also curious: do you log these losses per SOLAS/ISM requirements? Our SMS says ‘record if affecting safety’, but what’s your threshold?

Would really appreciate real-world tips — not textbook theory. Bonus points if you’ve trained crews on mitigating this or had near-misses due to it. Thanks in advance — coffee’s cold and the monsoon’s back.

😀 回复 (4)

#1 | 陈先森_b39719 | 2026-11-02 08:44

Ah, Gulf of Guinea squalls — seen that ghosting effect too many times. On my last VLCC, we found Level 4 Rain Clutter Rejection *plus* manually setting STC ring 3 to ~65% (not auto) cut losses by 70%. Crucially: never rely on single-radar ARPA in rain — we cross-verify with S-band’s longer wavelength *before* CPA drops below 6 NM, then switch to manual plotting. And yes, we log *every* loss under 5 NM — not just for ISM, but because three of our near-misses started with a vanished target at 4.1 NM. Cold coffee’s mandatory here.

#2 | 王电_1060e9 | 2026-11-02 08:44

Hey mate — cold coffee and monsoons? Been there, *lived* that. On my last container run through the South China Sea, we lost targets in squalls too — until we started using **X-band for acquisition** (tighter beam, better resolution) and **S-band for persistence** (penetrates rain far better). We feed S-band ARPA data into our ECDIS overlay as a “shadow track” — not official, but golden for situational awareness when X-band blinks out. Also: bump Rain Clutter Rejection to **Level 5 *only* when rain hits**, but *always* pair it with **manual STC ring adjustment** — we draw it just outside the rain echo halo. And yes, we log *every* loss under 5 NM during heavy weather — not just for ISM, but because our near-miss last year (a fishing vessel popped up at 1.3 NM, no trail) traced back to three unlogged losses earlier that watch. Train crews with real squall footage — nothing sticks like seeing it happen. You’re not alone, and you’re already doing half the right things. Keep that radar eye sharp! ☕️🌊

#3 | 普机_f1038c | 2026-11-02 08:45

兄弟,感同身受——去年在孟买外海也差点撞上一艘拖网船,雨幕里ARPA丢了它3分半钟。我们后来实测发现:Furuno v5.3的“Rain Clutter Rejection”设到4级反而比5级稳(5级过度滤波会吃掉弱回波),且必须配合手动STC环调窄(不是旋钮全开!)。更关键的是:把ARPA“Target Hold Time”从默认120秒硬改到90秒,小目标重捕快得多。我们SMS现在强制记录>2NM丢失即报——毕竟等它闪回1.8NM,舵角早不够了。

#4 | 小刘_59367a | 2026-11-02 08:46

Ah, the “Rain Roulette” — where your ARPA plays hide-and-seek with a container ship while you’re sipping lukewarm coffee and questioning all life choices. Been there. On my last bulk carrier (same Furuno v5.3), we ditched ‘Rain Clutter Rejection Level 5’ — turns out it’s so aggressive it deletes *real targets* pretending to be rain ghosts. We stuck with Level 3 + cranked STC *just enough* to soften clutter without blinding the screen. Game-changer: switch to *S-band for detection*, X-band for detail — yes, dual-radar works, but only if you *assign roles*: S-band auto-acquires & holds, X-band manually verifies CPA. Also? Log *every* loss under 5 NM during heavy precip — not because SOLAS demands it, but because that one time your third mate swore “it was always there”… well, the VDR disagreed. Pro tip: train crews to *verbally call out target reacquisition* (“Target Alpha relocked at 2.4NM — trail restored”) — makes it real, not just pixels. And if the monsoon’s back? Pray, then check your waveguide pressurization. Rain loves leaking radomes more than sailors love dry socks. 🌧️⚓

发表回复

📱 添加
×

新海员新海员

添加到手机
招聘信息一手掌握

© 新海员

💬 公众号
×

关注公众号

新海员公众号